- ページ 22

洗濯機 Zanussi FL 1008のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi FL 1008 24 ページ。 Washing machine fl 808; fl1008
Zanussi FL 1008 にも: 取扱説明書 (22 ページ)

Zanussi FL 1008 取扱説明書

Something not working?

Problems which you can resolve yourself, before calling the After Sales Service.
During machine operation it is possible that the END (FIN) light starts to flash:
4 flashes= the door has not been closed
2 flashes= the machine does not empty
1 flash= the machine does not fill.
Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty and/or
does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
Possible cause
• The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The programme selector dial is not positioned
correctly and the START/PAUSE button has not
been depressed.
• The 8H / 4 H (Delay Start) option has been selected.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The RINSE HOLD
been selected.
• The drain pump is clogged.
• The laundry is not evenly distributed in the drum.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the filter.
• The pump has not been fully screwed in after
cleaning.
• Too little or too much detergent has been used.
• An unsuitable detergent has been used.
• Stubborn stains have not been treated prior to
washing.
• The correct programme/temperature was not
selected.
• Excessive laundry load.
22
option has
or NO SPIN