- ページ 20

洗濯機 Zanussi FL 1016/AのPDF 使用上の注意をオンラインで閲覧またはダウンロードできます。Zanussi FL 1016/A 32 ページ。 Zanussi washing machine instructions for the use and care
Zanussi FL 1016/A にも: 取扱説明書 (32 ページ)

Zanussi FL 1016/A 使用上の注意
Amount of wash powder in grammes fora
full load.
Hardness
Pre-wash | Main wash]
Main wash
following
pre-wash
Average
230
Very hard
For half loads use about 3/4 of quantity.
Liquid detergents
Liquid detergents may be very useful
above all for the low and medium
temperature washing of delicate items
or those which are not very dirty.
The dispenser drawer also allows the
use of liquid detergents.
In this case, you must select
programmes without prewash.
The liquid detergent should be poured
into the compartment «b» immediately
before starting the programme.
Using fabric conditioners
When you want to use a conditioner, put
the measured amount (follow
manufacturers' instructions) into
compartment 'c' in the washing powder
dispenser at the same time as you put in
the washing powder. Be careful not to fill
the compartment above the level of the
filter. The conditioner will be
automatically used by the machine at the
appropriate time. Remember to close the
drawer (fig. 6) gently.
20
To start the machine
Check that:
the main switch is on;
the door is properly closed;
the water is turned on.
Select the programme required by
pushing in the programme selector dial
and turning it clockwise to the required
letter. Pull out the knob. The pilot light
will then come on and the machine will
start. The machine will automatically
carry out all the operations up to the end
of the chosen programme. Then it will
stop. The pilot light will go out.
If, after the start of a programme, you
find you have selected the wrong one,
push the selector knob in to stop the
machine. Then turn the dial clockwise to
the correct position and pull the knob
out to restart the washing cycle.
At the end of the programme push the
knob in to switch the machine off.
Unloading the clothes
The drum door remains automatically
locked for 1-2 minutes after the machine
has been switched off. You can then open
the door and unload the machine. If you
have been using a gentle wash
cycle do not forget to set the
machine to drain the water
(programme W or X) before
opening the door.