- ページ 24

洗濯機 Zanussi FL 1090のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi FL 1090 26 ページ。 Front-loading washing machine

ページを印刷する

1. Something Not Working

Something not working?

Problems which you can resolve yourself.

During machine operation it is possible that one of the following alarm codes appears on the display:

- E10: problem with the water supply

- E20: problem with water draining

- E40: door open

Some audible warning signals can also be heard.

Once the problem has been eliminated, press the START/PAUSE button

all checks, the problem persists, contact your local Service Centre.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty and/or

does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

• The machine vibrates or is noisy:

• The door will not open (the relevant

light is on):

to restart the programme. If after

Possible cause

• The door is not firmly closed. (E40)

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The START/PAUSE (INICIO / PAUSA) button has

not been depressed.

• The DELAY START (INICIO DIFERIDO) option

has been selected.

• The water tap is closed. (E10)

• The inlet hose is squashed or kinked. (E10)

• The filter in the inlet hose is blocked. (E10)

• The door is not properly closed. (E40)

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked. (E20)

• The RINSE HOLD option has been selected.

• The drain pump is clogged. (E20)

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• The cap on the emergency emptying hose has not

been replaced after cleaning the filter.

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct temperature/fabric was not selected.

• Excessive laundry load.

• The transit bolts and packing have not been

removed.

• The support feet have not been adjusted.

• The laundry is not evenly distributed in the drum.

• Maybe there is very little laundry in the drum.

• The programme is still running, the drum is turning.

• The door lock has not yet released.

• The water level is above the bottom edge of the door.

• The machine is heating the water.