- ページ 20
洗濯機 Zanussi ZWS 588のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZWS 588 24 ページ。 Front-loading washing machine
ページを印刷する
- 1. Table of Contents
- 2. Safety Information
- 3. Product Description
- 4. Control Panel
- 5. First Use
- 6. Daily Use
- 7. Helpful Hints and Tips
- 8. Washing Programmes
- 9. What to Do if
- 10. Technical Data
- 11. Consumption Values
- 12. Care and Cleaning
- 13. Installation
- 14. Electrical Connection
- 15. Environment Concerns
Unscrew the three bolts.
Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be tight to adjust
as they incorporate a self locking nut, but the machine
MUST be level and stable.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation. Never place card-
board, wood or similar materials under the machine to
compensate for any unevenness in the floor.
20
Slide out the relevant plas-
tic spacers.
If necessary, check the
setting with a spirit level.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to new
pipework or to pipework that has not been used for
some time, run off a reasonable amount of water to flush
out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
35°
The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the hose
to the left or right depending on the position of your
water tap. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
Caution! The inlet hose must not be lengthened. If
it is too short and you do not wish to move the tap,
you will have to purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three ways:
Connect the hose to a tap
with a 3/4" thread. Always
use the hose supplied with
the appliance.
45°