- ページ 10

カーエレクトロニクス Directed CHRYSLER4のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Directed CHRYSLER4 16 ページ。 Door lock/convenience and override firmware for most chrysler, dodge and jeep.

ページを印刷する

Platform: DBALL2

Firmware:

CHRYSLER4

Module Reset

A module reset will erase the module programming

configured on the module using the web

D2D Installation

If required for your installation, c

14-pin harnesses to the module Press

rogramming button

W2W Installation

If required for your installation, connect the 10-pin & 12-pin

harnesses to the module Press

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the

rogramming button.

Hard Reset

Warning gainst xecuting a Hard Reset!

A hard reset will erase all the data stored in the

default values. After a hard reset, you may have to reconfigure your

not part of the default configuration. See the

D2D Installation

If required for your installation, c

14-pin harnesses to the module Press

rogramming button

W2W Installation

If required for your installation, connect the 10-pin & 12-pin

harnesses to the module Press

button, then connect the 14-pin harness to the module.

Wait 3 seconds until the

until the

LED starts to flash orange

Release the programming button. The

only

config

tool will remain untouched

onnect the 10-pin 12-pin

and

hold the

, then connect the 4-pin D2D harness.

and

hold the rogramming

LED turns

solid

orange then release the

The

LED

then turns

solid red.

DBALL

and will change all the settings configured on the module to its

Feature & Option List

onnect the 10-pin 12-pin

and

hold the

, then connect the 4-pin D2D harness.

and

hold the rogramming

LED turns

solid

orange

and

red.

LED

turns

(bypass, convenience and vehicle detection). All the settings

DBALL

if your installation requires specific options,

section of this guide.

, and w

ait

10 more seconds

solid red.

Rev.: 20170818

Page 10

Solid

Release

Solid

Flashes

Release

Solid