ページを印刷する
Starting a washing programme
In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
All the push buttons indicator lights will illuminate.
4. Setting and starting the programme
Press the push button corresponding to the required
programme (see "Washing programmes" chart).
The indicator light corresponding to the programme
remains illuminated while the other programme indicator
lights will turn off.
The start of the washing programme will occur only once
closed the door, until then it is possible to change the
programme selection simply pressing the push button of
another programme.
Close the dishwasher door, the programme will start
automatically.
5. Interrupting, changing or cancelling
a washing programme
Interrupt, change or cancel a washing programme in
progress ONLY if it's absolutely necessary
To interrupt a washing programme
Attention! Hot steam may escape when the door is
opened. There is risk of scalding. Open the door
carefully.
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
pressing the On/Off (in this case all the indicator
lights turn off). Press the On/Off push button again;
the programme will start from the point in which it was
interrupted.
To change a washing programme
Open the dishwasher door.
Press the push button of the programme you want to
select for about 6 seconds, the indicator light of the
running programme starts to flash.
The indicator light of the running programme turns off
and at the same time the indicator light of the new
selected programme will illuminate.
The new programme will start automatically once the
dishwasher door is closed.
To cancel a washing programme
Open the dishwasher door.
Press simultaneously the function push buttons 2 and 3
for about 2 seconds, the indicator light of the running
programme will start flashing. After about 2 seconds all
the indicator lights of the programme push buttons will
illuminate indicating that the running programme has
been cancelled and that the machine has returned to
setting mode.
It is now possible to select and start a new washing
programme.
6. Setting/cancelling the "delay start"
The setting of the delay start occurs after selecting
the programme.
Setting the "delay start"
Press the "delay start" push button until the indicator light
corresponding to the chosen hours flashes (3, 6 or 9
hours).
The countdown will start only once that the door has
been closed, until that moment it is still possible to
change the selection made. If the countdown has not yet
started (closen door) it is also possible to cancel the
delay selection by simply pressing the "delay start" push
button until the indicator lights of the hours are no longer
illuminated. (In this case the selected washing
programme will start automatically once the door is
closed).
Close the door, the countdown will start automatically.
The countdown will decrease with step of 3 hours.
The opening of the door will not stop the countdown.
Once the delay start has elapsed the programme will
start automatically.
Cancelling a "delay start" in progress
To cancel a delay start in progress you must follow the
same procedure as for cancelling a running programme
(see "To cancel a washing programme") .
In this case the washing programme must be set again.
7. End of the washing programme
The dishwasher will automatically stop and an
intermittent audible signal informs you of the end of the
washing programme.
The indicator light of the programme just ended remains
illuminated and the end of programme indicator light
will illuminate.
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
Switch off the dishwasher by pressing the On/Off push
button.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Leave the dishes in the dishwasher for approx. 15
minutes, with the door ajar, after the end of programme
so that they dry better and will be cooler.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
29