- ページ 29

食器洗い機 Zanussi ZT 6810のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZT 6810 32 ページ。 Zanussi instruction booklet dishwasher zt 6810

Building-in

This dishwasher is designed to be fitted under a kitchen

counter or worksurface.

It is essential that the recess dimensions indicated in the

diagram are followed.

No further openings for venting of the dishwasher are

required, but only to let the water fill and drain hose and

power supply cable pass through.

The recess height may be anywhere between 820 and

880 mm from the floor as the dishwasher incorporates

adjustable feet (max 60 mm).

A distance of 2 mm should be allowed between the top

of the dishwasher and the counter top.

Adjusting the height of the

appliance

To adjust the height proceed as follows:

1. Loosen or tighten the two front feet.

2. The rear foot is adjusted by turning the screw in

the middle of the front kick plate to the left or

right.

A pad is supplied for the rear foot to make sliding the

appliance in and out of the recess easier.

To fit the pad, press it onto the rear foot.

If required, the dimensions of this pads can be reduced

by breaking it where marked.

Good levelling is essential for correct closure and

sealing of the door. When the appliance is correctly

levelled, the door will not catch on the levelling spacers,

either side of the cabinet.

If the door does not close correctly, loosen or tighten the

adjustable feet until the machine is perfectly level.

II64

II52

IN11

IN12

PFI20UK