- ページ 4
ホブ Zanussi 949 750 995のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi 949 750 995 21 ページ。
Where the appliance is directly connected to the power supply,
•
an all-pole isolating switch with a contact gap is required.
Complete disconnection in compliance with the conditions
specified in overvoltage category III must be guaranteed. The
earth cable is excluded from this.
When you route the mains cable, make sure that the cable
•
doesn't come into direct contact (for example using insulating
sleeving) with parts that can reach temperatures of more than
50°C above room temperature.
WARNING: Use only hob guards designed by the
•
manufacturer of the cooking appliance or indicated by the
manufacturer of the appliance in the instructions for use as
suitable or hob guards incorporated in the appliance. The use
of inappropriate guards can cause accidents.
SAFETY INSTRUCTIONS
This appliance is suitable for the following markets:
PT ES
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
WARNING! Risk of injury or damage
to the appliance.
•
Remove all the packaging.
•
Do not install or use a damaged appliance.
•
Follow the installation instructions supplied with
the appliance.
•
Keep the minimum distance from other
appliances and units.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Seal the cut surfaces with a sealant to prevent
moisture from causing swelling.
•
Protect the bottom of the appliance from steam
and moisture.
•
Do not install the appliance next to a door or
under a window. This prevents hot cookware
from falling from the appliance when the door or
the window is opened.
•
If the appliance is installed above drawers make
sure that the space, between the bottom of the
4
appliance and the upper drawer is sufficient for
air circulation.
•
The bottom of the appliance can get hot. Install
a non-combustible separation panel under the
appliance to prevent access to the bottom.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•
All electrical connections should be made by a
qualified electrician.
•
The appliance must be earthed.
•
Before carrying out any operation make sure
that the appliance is disconnected from the
power supply.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Make sure the appliance is installed correctly.
Loose and incorrect electricity mains cable or
plug (if applicable) can make the terminal
become too hot.
•
Use the correct electricity mains cable.
•
Do not let the electricity mains cable tangle.
•
Make sure that a shock protection is installed.
•
Use the strain relief clamp on the cable.
•
Make sure the mains cable or plug (if
applicable) does not touch the hot appliance or
hot cookware, when you connect the appliance
to a socket.