ページを印刷する
appliance and the upper drawer, is sufficient for
air circulation.
•
The underside of the appliance can get hot
when in use. If an oven has not been fitted
underneath the hob and underside of the
appliance is accessible and could allow a user
or items stored beneath the hob to come in
direct contact with the underside of the hob, an
intermediate protection panel must be fitted.
•
Plywood or kitchen carcass material is
acceptable for the panel.
•
The panel must be removable for servicing.
Screws used to fix the panel must be accessible
after installation.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electrical
shock.
•
All electrical connections should be made by a
qualified electrician.
•
The appliance must be earthed.
•
Before carrying out any operation make sure
that the appliance is disconnected from the
power supply.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Make sure the appliance is installed correctly.
Loose and incorrect electricity mains cable or
plug (if applicable) can make the terminal
become too hot.
•
Use the correct electricity mains cable.
•
Do not let the electricity mains cable tangle.
•
Make sure that a shock protection is installed.
•
Use the strain relief clamp on the cable.
•
Make sure the mains cable or plug (if
applicable) does not touch the hot appliance or
hot cookware, when you connect the appliance
to the near sockets
•
Do not use multi-plug adapters and extension
cables.
•
Make sure not to cause damage to the mains
plug (if applicable) or to the mains cable.
Contact our Authorised Service Centre or an
electrician to change a damaged mains cable.
•
The shock protection of live and insulated parts
must be fastened in such a way that it cannot be
removed without tools.
•
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•
If the mains socket is loose, do not connect the
mains plug.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
4
•
Use only correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.
•
The electrical installation must have an isolation
device which lets you disconnect the appliance
from the mains at all poles. The isolation device
must have a contact opening width of minimum
3 mm.
GAS CONNECTION
•
All gas connections should be made by a
qualified person.
•
Before installation, make sure that the local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.
•
Make sure that there is air circulation around the
appliance.
•
The information about the gas supply is on the
rating plate.
•
This appliance is not connected to a device,
which evacuates the products of combustion.
Make sure to connect the appliance according
to current installation regulations. Pay attention
to requirements regarding adequate ventilation.
USE
WARNING! Risk of injury, burns and
electrical shock.
•
Remove all the packaging, labelling and
protective film (if applicable) before first use.
•
Use this appliance in a household environment.
•
Do not change the specification of this
appliance.
•
Make sure that the ventilation openings are not
blocked.
•
Do not let the appliance stay unattended during
operation.
•
Set the cooking zone to "off" after each use.
•
Do not put cutlery or saucepan lids on the
cooking zones. They can become hot.
•
Do not operate the appliance with wet hands or
when it has contact with water.
•
Do not use the appliance as a work surface or
as a storage surface.
•
When you place food into hot oil, it may splash.
WARNING! Risk of fire and explosion
•
Fats and oil when heated can release flammable
vapours. Keep flames or heated objects away
from fats and oils when you cook with them.