- ページ 6

ホブ Zanussi ZGG66424のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGG66424 16 ページ。 Gas hob
Zanussi ZGG66424 にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (21 ページ)

ページを印刷する

Electrical Requirements

Permanent electrical installation must comply with the lat-

est I.E.E. Regulations and local Electricity Board regula-

tions. For your own safety the installation must be done

by a qualified electrician (e.g. your local Electricity Board,

or a contractor who is on the roll of the National Inspec-

tion Council for Electrical Installation Contracting [NICE-

IC]).

The manufacturer declines any liability if these safety

measures are not observed.

The appliance must be connected to a 230 V 50 Hz AC

electrical supply.

Before activating the appliance, make sure the electrical

supply voltage is the same as that indicated on the rating

plate. The rating plate is located on the bottom of the ap-

pliance.

The appliance is supplied with a 3 core flexible supply

cord with a 3 amp plug. If it is necessary to change the

fuse, use a 3 amp ASTA-approved (BS 1362) fuse.

Green and Yellow

3 amp fuse

Brown

Cord clamp

Blue

Should the plug need to be replaced for any reason, the

wires in the mains lead are coloured in accordance with

the following code:

Green and yellow

Blue

- Earth

- Neutral

Brown

Connect the green and yellow (earth) wire to the ter-

minal in the plug which is marked with the letter 'E'

or the earth symbol

low.

Connect the blue (neutral) wire to the terminal in the

plug which is marked with the letter 'N' or coloured

black.

Connect the brown (live) wire to the terminal in the

plug which is marked with the letter 'L' or coloured

red.

There must be no cut or stray strands of wire present. The

cord clamp must be secured on the outer sheath.

Warning! Make sure that the cut off plug is disposed

of safely. A cut off plug put into a 13 amp socket is

a safety hazard. There is a risk of electrical shock.

Important! The replacement of the electrical cable must be

done by a qualified electrician or competent person,

according to the current regulations.

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F T90

or equivalent type. Make sure that the cable section is ap-

plicable to the voltage and the working temperature. The

yellow/green earth wire must be approximately 2 cm lon-

ger than the brown (or black) phase wire.

Building In

min. 600 mm

min. 450 mm

min. 55 mm

30 mm

10 mm

3 mm

- Live

, or coloured green and yel-

min. 650 mm

560 mm

11 mm