- ページ 4

ホブ Zanussi ZGG66424のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGG66424 16 ページ。 Gas hob
Zanussi ZGG66424 にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (21 ページ)

ページを印刷する

• Disconnect the appliance from the elec-

trical supply, before you do the mainte-

nance work or you clean it.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• Install correctly to give anti-shock protection.

• A loose and incorrect mains plug and socket

connections can make the terminal become

too hot.

• A qualified electrician must install the clamp-

ing connections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains connection cable and

replace the damaged mains cable with appli-

cable cable. Speak to your local Service

Force Centre.

• The appliance must have the electrical instal-

lation which lets you disconnect the appli-

ance from the mains at all poles with a con-

tact opening width of minimum 3 mm.

Installation

Warning! The following instructions about

installation, connection and maintenance

must be carried out by qualified personnel in

compliance with standards and local

regulations in force.

Important safety requirements

This hob must be installed in accordance with

the Gas Safety (Installation and Use) Regula-

tions (Current Edition) and the IEE Wiring Reg-

ulations (Current Edition).

For appliances installed in the Republic of Ire-

land please refer to NSAI- Domestic Gas In-

stallation I.S. 813 Current Editions and the ET-

CI Rules for Electrical Installations.

Provision for ventilation

Detailed recommendations are contained in the

following British Standards Codes Of Practice:

B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891

Current Editions.

The hob should not be installed in a bed sitting

room with a volume of less than 20 m³. If it is

installed in a room of volume less than 5 m³ an

• If the fixing bracket is near to the terminal

block, always make sure the connection ca-

ble does not come in contact with the edge

of the bracket.

• You must have correct isolation devices: line

protecting cut-outs, fuses (screw type fuses

removed from the holder), ground leakage

trips and contactors.

Disposal of the appliance

• To prevent the risk of physical injury or dam-

age

– Disconnect the appliance from the power

supply.

– Cut off the mains cable where it connects

with the appliance and discard it.

– Flat the external gas pipes if there are fit-

ted.

– Speak to your local authorised facilities for

disposal of your appliance.

air vent of effective area of 100 cm² is required.

If it is installed in a room of volume between 5

m³ and 10 m³ an air vent of effective area of 50

cm² is required, while if the volume exceeds 11

m³ no air vent is required.

However, if the room has a door which opens

directly to the outside no air vent is required

even if the volume is between 5 m³ and 11 m³.

If there are other fuel burning appliances in the

same room, B.S. 5440 Part 2 Current Edition,

should be consulted to determine the requisite

air vent requirements.

For appliances installed in the Republic of Ire-

land please refer to the NSAI- Domestic Gas

Installation I.S. 813 Current Editions Table

Four.

Location

The hob may be located in a kitchen, a kitchen/

diner or bed sitting room (with a volume greater

than 20 m³), but not in a bathroom or shower

room.

The minimum distance combustible material

can be fitted above the hob in line with the