- ページ 11

ホブ Zanussi ZGG67412のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGG67412 16 ページ。
Zanussi ZGG67412 にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (32 ページ)

ページを印刷する

4. With a thin screwdriver, adjust the by-pass

screw position.

A) The by-pass screw

• If you change from natural gas G20 20 mbar

to liquid gas, fully tighten the adjustment

screw in.

• If you change from liquid gas to natural gas

G20 20 mbar, undo the by-pass screw ap-

proximately 1/4 of a turn.

Warning! Make sure the flame does not

go out when you quickly turn the knob from

the maximum position to the minimum position.

Electrical connection

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

• The appliance must not be connected with an

extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree with

the latest I.E.E. Regulations and local Electricity

Board regulations. For your own safety the in-

stallation must be done by a qualified electrician

(e.g. your local Electricity Board, or a contractor

who is on the roll of the National Inspection

Council for Electrical Installation Contracting

[NICEIC]).

www.zanussi.com

The manufacturer refuses to be held

responsible, if these safety measures

are not abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an effi-

cient earth connection in compliance with

the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the ap-

pliance installed.

The appliance is supplied with a 3 core flexible

powercable with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-ap-

proved (BS 1362) fuse.

A) Green and Yellow

B) 3 amp fuse

C) Brown

D) Cord clamp

E) Blue

The wires in the cord are coloured as follows:

or E — Earth terminal