- ページ 25

ホブ Zanussi ZGG96624のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGG96624 44 ページ。 Hob
Zanussi ZGG96624 にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (48 ページ)

ページを印刷する

5. If you change:

• from natural gas G20/G25 20/25 mbar

to liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20/G25

20/25 mbar, undo the bypass screw

approximately 1/4 of a turn (1/2 of a turn

for Triple Crown burner).

WARNING!

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the

minimum position.

Electrical connection

• Make sure that the rated voltage and type of

power on the rating plate agree with the

voltage and the power of the local power

supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a correct

plug which can hold the load that the rating

plate rates. Make sure that you install the

plug in a correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown

(or black) phase cable to the

terminal which has a letter "L". Keep

the phase cable connected at all

times.

www.zanussi.com

Connection cable

To replace the connection cable use only the

special cable or its equivalent. The cable type

is: H05V2V2-F T90.

Make sure that the cable section is applicable

to the voltage and the working temperature. The

yellow / green earth wire must be approximately

2 cm longer than the brown (or black) phase

wire.

Building In

min. 450 mm

min. 55 mm

30 mm

10 mm

3 mm

A) supplied seal

B) supplied brackets

CAUTION!

Install the appliance only on a

worktop with flat surface.

Possibilities for insertion

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

min. 650 mm

830 mm

27 mm