- ページ 8

ホブ Zanussi ZGO63414のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGO63414 40 ページ。 58 cm, 4 zones
Zanussi ZGO63414 にも: ユーザーマニュアル (48 ページ), マニュアル (44 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (40 ページ)

Zanussi ZGO63414 ユーザーマニュアル
ple to warm up. If not, the gas supply will
be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
correct positions.
Burner cap and crown
1
Thermocouple
2
Ignition candle
3
Warning! Do not keep the control knob
pushed for more than 15 seconds.

Helpful hints and tips

Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the
flame to barely simmer the liquid.
Warning! Use pots and pans with bottom
applicable to the dimension of burner.
Do not use cooking vessels on the hotplate that
overlap its edges.
Burner
Rapid
Semi-rapid
Auxiliary
Warning! Do not use cast iron pans,
potstones, grill or toaster plates on gas
burners.
8
1
2
3
Diameters of cookware
180 - 260 mm
120 - 220 mm
80 - 180 mm
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum
1 minute.
Important! In the absence of electricity you
can ignite the burner without electrical device;
in this case approach the burner with a flame,
push the relevant knob down and turn it
counter-clockwise to maximum gas release
position.
If the burner accidentally goes out, turn the
control knob to the off position and try to
light the burner again after minimum 1 minute.
The spark generator can start automatical-
ly when you switch on the mains, after in-
stallation or a power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the sym-
bol
.
Warning! Always turn the flame down or
switch it off before you remove the pans
from the burner.
Warning! Do not put the aluminium foil on
the hob top to keep the surface clean
during the cooking
Warning! Pots must not enter the control
zone. Flame will heat up the control zone.
Do not put the same pan on two burners.
www.zanussi.com