- ページ 20

ホブ Zanussi ZGRW 2504-7のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZGRW 2504-7 48 ページ。

Installation

• Cut out worktop to prescribed

measurements of templates (saw

exactly along the scribing).

• Check seal for perfect fit and

overall cover (see detail A).

• Lower the ceramic hob into place

and align correctly.

Fastening according to Fig. 1

• Tighten bracket against the underside of the worktop.

• Using a standard or Phillips screwdriver, tighten the

tension clamps evenly starting at the centre and

moving diagonally until the built-in rim is tight on the

worktop.

• Do not overtighten!

• Do not use an electric or pneumatic sdrewdriver

without an adjustable safety clutch (pos. 1-1.1 Nm).

The installation of the control box or the oven will be

carried out according to separate instructions. In order

not to damage the appliance, the hob may only be

connected to control boxes which are approved by the

supplier of the ceramic hob.

The distance between the underside of the hob and the

furniture underneath must be at least 20 mm (see fig.2).

The electrical connection of the ceramic hob should

only be carried out by a trained technician.

The protection against accidental contact must be

ensured by proper installation.

Attention: • If there are any repairs to be effected, the

appliance must be non-tensioned (e.g. by

unscrewing the fuse).

• As soon as a crack is visible in the top,

the appliance has to be disconnected from

the mains.

In terms of fire protection, the appliance conforms

to type Y (IEC 335-2-6). Only appliances of this type

may be installed to cupboards or walls.

detail A

cutout dimensions: 560 x 490 mm

hob dimensions

Fig.1

Fig.2

: 570 x 500 mm