- ページ 9
冷凍庫 Zanussi ZBF22456S1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZBF22456S1 17 ページ。
ページを印刷するProblem
A rectangular symbol is shown
instead of numbers on the
Temperature Display.
The compressor operates con-
tinually.
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the display.
Possible cause
The door is left open.
The temperature in the appli-
ance is too high.
Temperature sensor prob-
lem.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The QuickFreeze is switched
on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The QuickFreeze or Quick-
Chill function is switched on.
The appliance is in demon-
stration mode.
Solution
Close the door.
Contact a qualified electrician or
contact the nearest Authorised
Service Centre.
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible).
Refer to "Operation".
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze function".
Refer to "Closing the door".
The compressor starts after a pe-
riod of time.
Attach the melting water outlet to
the evaporative tray.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to
set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
Keep the OK pressed for approx-
imately 10 seconds until a long
sound is heard and display shuts
off for a short time.
9