- ページ 8

冷凍庫 Zanussi ZFC 220のPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZFC 220 9 ページ。 Chest freezer zfc 220; zfc 310
Zanussi ZFC 220 にも：操作および設置マニュアル (4 ページ)

ページを印刷する

and closing the lid. Open the lid after a while, and remove

the layer of ice carefully.

The defrost water can be collected in a bowl as shown in

the drawing.

Do not try to speed up defrosting by using anything other

than hot water, since this may damage the freezer. After

defrosting, clean the inside of the freezer.

IMPORTANT

Remember to replace the plug in the drip water

drain.

HOW TO CLEAN YOUR FREEZER INSIDE

Remove the plug from the mains socket, and remove all

loose accessories before cleaning the freezer.

The best time to clean your freezer is after defrosting and

before the electricity supply is connected again.

Use a damp cloth to clean your freezer. Use hot water,

and a mild, non-aromatic cleaning agent.

After cleaning the freezer, clean the basket/baskets

before replacing them.

Defect:

Check if:

Freezer not

Green light not on

cold enough

Green and red light on

Green light on, red

light not on

Freezer too

Yellow light on

cold

Yellow light not on

Too much

Lid does not close

frost

completely

formed

Lot of moisture in the

room

Goods packed poorly

IF SOMETHING DOES NOT

WORK

IF YOUR FREEZER DOES NOT

FUNCTION SATISFACTORILY

Check the following before calling for service staff:

If you are still unable to solve the problem, summon the

assistance of authorised service staff.

Do not take any other steps. Incorrect procedure may

cause personal injury or lead to additional defects.

It is quite normal for the freezer to seem warm on the

outside occasionally, owing to the heat generated by the

freezing process. This heat also helps to prevent the

formation of moisture on the outside of the appliance

which could cause rust.

If the freezer has been switched off briefly, the

compressor may not start immediately when the current

is re-connected. This is quite normal.

Never use strong cleaning agents, scouring powder

or strongly aromatic cleaning agents to clean your

freezer inside, since this will damage the inside and

leave a strong smell.

EXTERNAL CLEANING

Wash the outer cabinet with warm soapy water. Do NOT

use abrasive products.

WHEN NOT IN USE

Possible cause:

Plug not connected correctly

Defect in switch or fuse

Power failure

Fresh food recently placed in freezer

Lid open too long

Thermostat set too warm

Lot of frost and ice formed

"Super" function active

Thermostat set too cold

Lid in contact with goods in

freezer

Moisture from washing machine,

tumble-dryer, etc.

Lot of moisture from goods

IN THE CASE OF A POWER FAILURE OR

BREAKDOWN

The hold-over period mentioned in the "Technical

Specification" section of this book refers to an estimated

time the freezer temperature will take to rise to an

unacceptable level for keeping frozen foods.

Providing the period of power failure or breakdown does

not exceed the hold-over period there will be no risk of

damage to the frozen food, providing you do not open the

lid during this period.

If the freezer is only half full or the lid is opened this will

reduce the hold-over time.

After the breakdown period you are recommended to

check the condition of food to ensure it has not started to

thaw. Frozen food must NOT be re-frozen once it has

thawed out. The following guidelines should assist you.

Ice cream:

IMPORTANT

Disconnect the appliance from the electricity supply.

Remove all goods from the freezer.

Clean the freezer as described above.

Leave the lid slightly open.

Action:

Check plug and socket

Check fuse, call electrician

Wait until current returns

Wait a couple of hours

Set thermostat colder

Defrost freezer

Press "Super" button out

Set thermostat warmer

Re-arrange goods, check that lid

closes correctly

Move freezer to a room with less

moisture, or air regularly

Re-pack goods, see under

"How to use"

Once

discarded.

thawed

should