- ページ 5
冷凍庫 Zanussi ZFT11105XVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZFT11105XV 17 ページ。
Full Loaded position
5
SWITCHING ON
Leave the appliance to stand upright for 4 hours
after installation.
Insert the plug into the wall socket.
1. Turn the Temperature Regulator clockwise to a
medium setting.
The Green Indicator Light will light up and remain lit
until the appliance is switched off.
2. Leave to run for 8 hours to allow the correct
temperature to be reached before placing food
inside.
The Red Indicator Light will stay on until the
correct temperature is reached.
3. When the appliance has reached the set
temperature (the Red Indicator Light has gone
out) adjust the Temperature Regulator
according to the quantity of the stored foods.
A few hours after starting up the Red
Indicator Light will go out to show that
the correct temperature has been
reached for the setting chosen and will
stay out to indicate that everything is in
order. It will come on if the freezer
temperature rises unduly for instance,
after opening the freezer door or
placing food inside the cabinet, but
the light should go out again when the
temperature returns to the correct
storage level.
DAILY USE
WARNING! Refer to Safety chapters.
FREEZING FRESH FOOD
The freezing (top) area is suitable for freezing fresh
food and storing frozen and deep-frozen food for a
long time.
To freeze fresh food, place it in the freezing (top)
compartment and leave it there for 24 hours.
Move frozen food in the storing (lower)
compartments to make room for another freezing.
The maximum amount of food that can be frozen in
24 hours is specified on the rating plate, a label
located on the inside of the appliance.
The freezing process lasts 24 hours: during this
period do not add other food to be frozen.
SWITCHING OFF
To turn off the appliance, disconnect the mains
plug from the wall socket.
TEMPERATURE REGULATION
The temperature within the appliance is controlled
by the Temperature Regulator situated on the
control panel.
To operate the appliance, proceed as follows:
•
turn the Temperature Regulator toward MIN to
obtain the minimum coldness.
•
turn the Temperature Regulator toward MAX to
obtain the maximum coldness.
In case of freezing less food volumes,
the Half Loaded setting is the most
suitable. In case of freezing large food
volumes, the Full Loaded setting is the
most suitable.
CAUTION! Do not place heavy nor
hot objects on top of the appliance to
avoid any damage.
STORAGE OF FROZEN FOOD
When first starting-up or after a period out of use,
before putting the products in the compartment let
the appliance run at least 8 hours on the higher
settings.
In the event of accidental defrosting,
for example due to a power failure, if
the power has been off for longer than
the value shown in the technical
characteristics chart under "rising
time", the defrosted food must be
consumed quickly or cooked
immediately and then re-frozen (after
cooling).
5