- ページ 12
冷凍庫 Zanussi ZRB934FX2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZRB934FX2 16 ページ。 Fridge freezer
ページを印刷する
Door reversibility
Warning! Before carrying out any operations,
remove the plug from the power socket.
A
B
E
F
C
D
• Open the doors. Un-
screw the middle hinge
(B). Remove the plastic
spacer (A).
• Remove the spacer (F)
and move to the other
side of the hinge pivot
(E).
• Remove the doors.
• Remove the left-hand
cover pin of the middle
hinge (C,D) and move to
the other side.
• Fit the pin of the middle
hinge (C) into the left-
hand hole of the lower
door.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the side edge of
the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
Environmental concerns
The symbol
on the product or on its packaging
indicates that this product may not be treated as
12
C
B
A
D
• Unscrew the lower hinge
(A)
• Remove the left-hand
cover pins (D) and move
to the other side.
• Re-screw the lower
hinge (A) on the oppo-
site side.
• Unscrew the lower hinge
pivot (B) and the spacer
(C) and place them on
the opposite side.
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
A
• Remove the plugs (1)on
the upper side of both
doors and move them to
the other side.
• Re-insert the lower door
on the lower hinge pivot.
• Insert the middle hinge
into the left drill of the
lower door.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
2
1
• Unscrew the upper
hinge pivot and place it
on the opposite side.
• Fit the upper door on the
upper door pivot.
• Re-insert the upper door
on the middle hinge piv-
ot slightly tilting both
doors.
• Re-screw the middle
hinge . Do not forget the
plastic spacer .
www.zanussi.com