- ページ 9
冷凍庫 Zanussi ZRT623WのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZRT623W 16 ページ。 Fridge freezer
ページを印刷する
1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power and specifically designed for household appli-
ances (the maximum power is shown on the lamp
cover).
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.
Installation
Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
Height
Width
Depth
Climate
SN
N
ST
T
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
tact the Service Center.
1404 mm
545 mm
604 mm
19 h
230 V
50 Hz
Ambient temperature
class
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
9