- ページ 14

冷凍庫 Zanussi ZTAE31EK1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZTAE31EK1 17 ページ。

ページを印刷する

Problem

Water flows on the floor.

The temperature in the appli-

ance is too low/too high.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

REPLACING THE LAMP

The appliance is equipped with a longlife LED

interior light.

Only service is allowed to replace the lighting

device. Contact your Authorised Service Centre.

Possible cause

The melting water outlet is not

connected to the evaporative

tray above the compressor.

The temperature is not set cor-

rectly.

The door is not closed correct-

ly.

The food products' tempera-

ture is too high.

Many food products are stored

at the same time.

The door has been opened of-

ten.

CLOSING THE DOOR

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation" chapter.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Solution

Attach the melting water outlet

to the evaporative tray.

Set a higher/lower tempera-

ture.

Refer to "Closing the door"

section.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Open the door only if necessa-

ry.