- ページ 11

冷凍庫 Zanussi ZUT 125WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZUT 125W 20 ページ。 Zanussi freezer instruction book
Zanussi ZUT 125W にも：仕様 (8 ページ)

ページを印刷する

If the appliance is not working correctly, please carry out the following checks before contacting your local

Zanussi Service Force Centre.

Problem

No power to the

appliance

The temperature in the

appliance is too high

The temperature in the

appliance is too low

Excessive frost and ice

has built up

The appliance is noisy.

If after the above checks your appliance still does not

operate correctly, contact your local Service Force

Centre.

Please note that it will be necessary to provide proof

of purchase for any in-guarantee service calls.

Operation failure

When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to

flash. The product will continue to operate with the use of a reserve system until the problem is

eliminated by the local service personnel.

Something Not Working

Possible Cause

No power at the socket.

There is a power cut.

The fuse has blown.

Thermostat control knob is set at „0".

The appliance is located in an unsuitable position.

The thermostat control knob is set too low.

The thermostat control knob is set too high.

The door has been left open.

Something is obstructing the door.

The door gasket is dirty.

The appliance is not level.

Check there is power at the socket.

Check there is not a power cut by checking the

household lights.

Check the fuse has not blown.

Check the thermostat control knob setting.

Check the ambient temperature is within the

appliances operating limits of 16 °C to 32 °C.

Check that the thermostat control knob is turned to

the correct setting relative to ambient conditions.

Set the thermostat control knob to a lower

position.

Check the door has not been left open.

Check nothing is preventing the door from closing.

Check the door gasket is intact and clean.

Check if the appliance stands stable (all four feet

should be on the floor).

In-guarantee customers should ensure that the

above checks have been made, as the

engineer will make a charge if the fault is not a

mechanical or electrical breakdown.

Solution