- ページ 14

換気フード Zanussi ZHC 925のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZHC 925 21 ページ。 Cooker hood
Zanussi ZHC 925 にも：取扱説明書 (20 ページ)

ページを印刷する

Fitting the Canopy Hood

Before starting to fix the canopy it will be

necessary to adjust the support brackets

S1 by turning the screws clockwise until

the limit of the thread is reached as

illustrated in Fig. 8.

Hook the canopy onto the two

4.2x44.4mm screws1 fitted as described

above and illustraed in Fig. 9.

Using a screw driver and spirit level,

adjust the screws S1 until the canopy is

level. Once the canopy is level, tighten

up the wall fixing screws to secure the

canopy.

Electrical connection and working

test

Before fitting the chimney to the canopy make

the electrical connection as described in the

section titled "ELECTRICAL CONNECTION".

When the electrical connection has been made,

test the three speed fan and worktop

illumination.

Venting

The hood is more effective when used in the

extraction mode (ducted to the outside).

Venting kits may be purchased through your

retailer or DIY store, and must be ducted to

an outside vent of 125mm (5").

The ducting used must be manufactured

from fire retardent material conforming

to the relevant British Standard or DIN

4102-B1.

When the cooker hood is ducted to the

outside the charcoal filter must be removed.

Recirculation

The cooker hood is supplied specified for use

in the recirculation mode, with the charcoal

filters fitted.

In the recirculation mode contaminated air is

passed through the charcoal filters to be

purified and recirculated into the kitchen

through the grille outlets on either side of the

chimney (G).

To assemble the recirculation duct, place the

'push-fit'recirculation extension pipe P over

the spigot on the top of the canopy; place the

'push-fit' spigot R on to the pipe P and insert

the extension pieces P1 into either side of the

spigot as illustrated in Fig. 10.

Fig. 8

Fig. 9

Fig. 10