- ページ 40

調理器 Zanussi ZCG 7700XのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi ZCG 7700X 44 ページ。 Zanussi instructrion manual gas cooktop zcg 7700x

ページを印刷する

Z C G 7 7 0 0 X

100

4. CONNECTING TO GAS

Fig

This appliance is designed to be installed with an appliance

flexible connection only.

Supply piping should not be less

that R³/8. Connection is made to the Rc ½ (½" B.S.P.)

female threaded entry pipe located just below the hotplate

level on the rear left hand side of the appliance. NOTE:

ONLY LIQUID SEALANTS TO BE USED WHEN INLET

GAS PIPE IS FITTED TO SHUT OFF VALVE I.E.: DO

NOT USE P.T.F.E. SEALANT TAPE. Check for gas

soundness after connecting to the gas supply.

The gas bayonet connector must be fitted in the shaded

area indicated in Fig.3. Take into account that it must be

possible to pull the appliance forward sufficiently. The hose

must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY

WITH BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE

SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION

UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND

OR LABEL.

All dimensions in mm

5. CONNECTION TO THE ELECTRICITY SUPPLY

WARNING: THIS APPLIANCE MUST BE EARTHED.

DO NOT EARTH THIS APPLIANCE TO THE GAS

SUPPLY PIPING.

This appliance must be connected to 220V-240V A.C.

50Hz supply. It is supplied with 2 metres of 5 amp 3 core

cable incorporating a moulded 13 amp plug, fitted with a 3

amp fuse, which can be plugged directly into the nearest

suitable socket. If this is not long enough, the supply cable

can be replaced totally by a longer cable at least 0.75mm²

nominal cross sectional area (24/0.2mm).

IF THE MOULDED PLUG IS CUT FROM THE CABLE

FOR ANY REASON, IT MUST BE DESTROYED OR

DISPOSED OF SAFELY, AS THE PROTRUDING

Fig.4

WIRES WILL BE AN ELECTRIC SHOCK HAZARD.

If any other type of plug is used it should incorporate a 5 amp fuse in either the plug or adapter or at the

distribution board.

If the cable has to be threaded through small apertures in cabinets etc., it may be disconnected from the

appliance, then re-connected to as shown in Fig.4.

DO NOT EXTEND THE CABLE USING PLASTIC OR CERAMIC CONNECTION TERMINAL BLOCKS

AND/OR INSULATION TAPE.

ALL EXTERNAL WIRING BETWEEN THE APPLIANCE AND THE ELECTRICAL SUPPLY SHALL

COMPLY WITH I.E.E. WIRING REGULATIONS.