- ページ 7
調理器 Zanussi ZCG551GNCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZCG551GNC 28 ページ。 Product manaul
ページを印刷する
For time change you must not set an auto-
matic function (Duration
the same time.
Preheating
Set an oven to maximum temperature and run
an empty oven for 45 minutes, to burn off any
Hob - Daily use
Warning! Refer to "Safety information"
chapter.
Lighting the burners
Warning! Be very careful when you use
open fire in a kitchen environment. The
manufacturer declines all responsibility in case
of misuse of the flame.
Always light the burner before you put
cookware on it.
1. Turn the knob to the maximum position
and push it down. When you push the
knob, the spark generator activates auto-
matically.
2. Keep the control knob pushed for approxi-
mately 5 seconds. This lets the thermocou-
ple warm up. If not, the gas supply is inter-
rupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
the correct positions.
9
8
7
6
www.zanussi.com
residue from the cavity surface. Accessories
can become hotter than in normal use. During
or End
) at
this period an odour can be emitted. This is
normal. Make sure the room is well ventilated.
1
2
3
4
5
6
7
8
9
Replacing burner parts
1. Carefully put the burner crown on the
2. Put the burner cap centrally on top of the
1
2
3. Try to light the burner. If the burner does
3
4
5
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum
1 minute.
Burner cap
Burner crown
Ignition candle
Thermocouple
Hob
Slots
Burner body
Location peg
Hole
burner body. Do not use force.
a) Make sure that the hole in the crown is
above the ignition candle.
b) Make sure that the location pegs are in
the slots in the burner body.
c) Let the crown fall freely onto the body.
d) Make sure that you can move the
crown a small distance from side to
side.
crown (enamel side up). Move the cap from
side to side and front to back to make sure
that it is correctly installed.
not ignite, adjust the crown and cap again.
Warning! Do not keep the control knob
pushed for more than 15 seconds.
7