- ページ 40

調理器 Zanussi ZCG7680のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZCG7680 44 ページ。 Zanussi user manual gas cooktop zcg7680, zcg7690
Zanussi ZCG7680 にも：ユーザーマニュアル (44 ページ)

ページを印刷する

Important: The wires in the mains lead fitted

to the appliance are coloured in accordance

with the following code.

Green and yellow

Blue

Brown

As the colours of the wires in the mains lead

of this appliance may not correspond with

the coloured markings identifying the

terminals in your plug, proceed as follows:-

The wire which is coloured green and yellow

must be connected to the terminals in the

plug which is marked with the letter E or by

the earth symbol (

green and yellow.

coloured blue, must be connected to the

terminal which is marked with the letter N or

coloured black. The wire which is coloured

brown, must be connected to the terminal,

which is marked with the letter L or coloured

red.

Ensure that the cable does not become

trapped when pushing the appliance into

position.

If a moulded plug is fitted.

In the event of replacing a fuse in the plug

supplied a 3 amp ASTA approved fuse to

B.S. 1362 must be fitted.

Note: The fuse cover must be refitted when

changing the fuse. In the event of losing the

fuse cover the plug must not be used until a

replacement fuse cover has been obtained

and fitted.

Connecting to gas supply

This appliance is designed to be installed

with an appliance flexible connection only.

Supply piping should not be less than R

Connection is made to the Rc ½ (½" B.S.P.)

female threaded entry pipe located just

below the hotplate level on the rear left hand

side of the appliance. NOTE: ONLY LIQUID

SEALANTS TO BE USED WHEN INLET

GAS PIPE IS FITTED I.E.: DO NOT USE

P.T.F.E. SEALANT TAPE.

-Earth

-Neutral

-Live

) or coloured green or

The wire which is

/8.