- ページ 22

調理器 Zanussi ZKG5030のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZKG5030 36 ページ。 Range cookers
Zanussi ZKG5030 にも：特徴と機能 (9 ページ), ユーザーマニュアル (36 ページ)

ページを印刷する

1. What to Do if

• Cleaners that contain bleach should not be

used as they may dull the surface finishes.

Harsh abrasives and scourers should also

be avoided.

Cleaning the outside of the

appliance

• Do not use abrasive cleaning materials e.g.

abrasive cream cleaners, wire wool pads or

scourers on painted or printed finishes as

damage may occur. Regularly wipe over the

control panel, control knobs, handles, doors

and appliance sides using a soft cloth and

hot soapy water. To prevent streaking, finish

with a soft cloth.

• Stainless Steel cream cleaners are abrasive

and should be avoided as they may dull the

surface finish. Any spillage on the stain-

less steel finish must be wiped off

immediately.

WARNING!

Do not attempt to remove any of the control

knobs from the appliance as this may cause

damage and is a safety hazard.

Cleaning the hob

• Clean the hob using a mild abrasive.

• Take care not to damage the spark electro-

des. If the spark electrodes are damaged the

burners will not light. You can remove the

pan supports, burner caps and burner

crowns to clean them. Again take care not

to damage the spark electrodes.

• Clean the burner crowns and pan supports

by soaking them in very hot soapy water.

• Aluminium based saucepans can leave

shiny metal marks on the pan supports. You

can remove any stubborn stains by scouring

with a soap impregnated steel wool pad. If

you look after the burner crowns and pan

supports in this way they will stay reasonably

clean. However the surface will dull with

time. After cleaning the appliance parts, dry

them thoroughly before you put them back.

When replacing hob burner parts

1. Crown to body. (Do not try to force the

crown on to the body). Make sure that the

hole in the crown is over the electrode.

Check that the location pegs sit in the slots

in the body. When the crown is in this po-

sition let it fall freely on to the body. Check

that the crown can be moved slightly from

side to side.

2. Cap to crown. Place cap centrally on the

top of crown (enamel side up). Move side-

ways and front to back to check the cap is

properly fitted.

3. Check for ignition. If a burner will not light

then you need to check the crown and cap

positions.