- ページ 8

セキュリティシステム Directed 322VTTのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Directed 322VTT 18 ページ。 Recreational vehicle security system

Connecting optional sensors

Connecting an optional plug-in shock sensor

A dual-stage shock sensor can be added to this security system. Adjustments are made via the rotary

control on the side of the sensor. Since the shock sensor does not work well mounted firmly to metal, we

do not recommend that you install the shock sensor on a metal surface. Instead, use a nylon tie-wrap and

attach the sensor to any of the vehicle's main harness.

Wiring the digital Tilt sensor

A digital Tilt sensor will self adjust 20 seconds after arming the security system. This 20 seconds is necessary

for the sensor calibration, do not attempt any testing during that period of time.

Install

1 amp Diode

Ground-when-armed

Red

Blue (-)

To INSTANT trigger input, zone 4

NOTE! The digital Tilt sensor must be installed horizontally with DEI 507M writing

facing up. Avoid installing the sensor on an angled or vertical position.

IMPORTANT ! Make sure that all openings on the impact sensor are sealed,

using sillicone and that you apply a layer of grease on the contacts. These pro-

cedures will prevent water infiltration which may damage internal circuits of the

digital Tilt/Motion sensor.

To the

Orange

of the Starter-Kill Relay

Red

Blue

Tilt Sensor

507M