- ページ 13

ページを印刷する

Directed Xpresskit DBALL2 インストレーション・マニュアル

Quick Reference Guide

DBALL/DBALL2-CHRYSLER6 Range Extender Ready (RXT) Installation

Range Extender Ready (RXT)

Range Extender Ready (RXT) is used to amplify the distance covered

by factory remote starters, which are built into the BCM of the vehicle.

The interface connects to the vehicle and uses the same codes as the

factory remote to remote start the vehicle. The runtime and features are

identical to the ones for the OEM remote starter. Some of the

advantages of RXT are greater distance coverage and 2-way

compatibility.

RXT Operations

The following table describes the behavior of the vehicle in relation to the RXT

feature. The following commands are performed on the aftermarket remote.

Command

Engine

Start

NOT running.

Start

Running.

Runtime

The runtime is equivalent to the amount set for the OEM remote starter, which can

be modified in some vehicles (refer to your vehicle owner's manual for more

information). A maximum of 2 remote starts can be performed between ignition

cycles.

Runtime Reset

The Runtime Reset feature allows the user to return the runtime to its predefined

value. This can only performed ONCE per remote start.

Result

The engine will be started.

The engine will be stopped.

List of Available Commands

Note that the information below is for Viper, Clifford and Python models. Icons and

commands may differ depending on the remote brand and model purchased. Refer

to your authorized installation center for more information.

Button(s)

Actions

Press & hold for 1 second to lock.

Press & hold for 1 second to unlock.

Press & hold for 1 second to remote

start.

Press & hold for 5 seconds to activate

the trunk release (optional).

Press

x1 +

rear hatch/tail glass release (optional).*

Press

x3 +

the panic mode.

Press

x1 +

remote starter runtime.

* This output is configurable. see your authorized installation center for more

information.

once, then

to activate the

3 times, then

to activate

once, then

to reset the