- ページ 5

ページを印刷する

Directed Xpresskit DBALL2 インストレーション・マニュアル

Platform: DBALL/DBALL2

Firmware:

CHRYSLER6 Range Extender Ready (RXT) Installation

SmartStart/XL202 Installation Notes

The DBALL Range Extender Ready (RXT) solution offers two (2) configuration options to control your system: RF Kit or

SmartStart (both sold separately). This section provides specific installation information for SmartStart and XL202.

SmartStart Revision A

SmartStart is optional and not included. It MUST be purchased separately.

Configuration Wires (White & Brown or Blue)

DBALL/

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

SmartStart Revision B

SmartStart is optional and not included. It MUST be purchased separately.

DBALL/

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit

The optional XL202 and antenna are not included and MUST be purchased separately.

DBALL/

DBALL2

XOVER

1. Use the D2D Crossover (XOVER) cable that is provided with XL202, and NOT the one in the DBALL package.

2. The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit & PKE Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

RF Kit, PKE & SmartStart BT Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

Cut Brown or Blue Loop

4 pins

2 pins,

not used

Configuration Wires (Gray & White)

Connect Gray wire to (-) Ground

5 pins

4 pins

2 pins,

not used

LED

XL202

Prog.

Button

LED

SmartStart

THIS SIDE UP

Rev.: 20150827

Page 5