- ページ 11

レーダー Blackberry RADAR H2 ITC100-1のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Blackberry RADAR H2 ITC100-1 30 ページ。 Magnet accessory
Blackberry RADAR H2 ITC100-1 にも：インストレーション・マニュアル (33 ページ), インストレーション・マニュアル (28 ページ), インストレーション・マニュアル (35 ページ), インストレーション・マニュアル (25 ページ), インストレーション・マニュアル (35 ページ)

3.4.7 Chassis/flatbed/heavy equipment installation procedure

If you are using BlackBerry Radar-L to track an asset without doors, or do not wish to

monitor door open/close events for your asset, you may mount the module on any flat,

vertical or horizontal surface that offers enough mounting area for the device. When

selecting a mounting location, carefully consider how the asset will be used in its

normal, day-to-day operation.

Do not place the assembly in a location where it is susceptible to damage from:

Normal usage activities, such as loading or unloading cargo.

•

Moving parts of the asset.

•

Road debris.

•

When mounting under a vehicle or piece of equipment, you must exercise a high

degree of caution to avoid serious damage to yourself or your equipment:

Do not install near exhaust sources, ignition sources, or fuel tanks.

•

Be careful when installing near pneumatic, hydraulic, and electrical lines to

•

prevent damage to these components during the installation process.

1. As indicated in Section 3.3 of this guide, record the module identifier and the asset

identifier the module will be paired with. For your convenience, you may quickly

create a record of the module and asset identifier pairings by removing the partially

attached label from the rear housing of the module and placing it on the installation

worksheet, next to the asset that will be tracked by this module.

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 41