- ページ 16

ページを印刷する

Directed Xpresskit DBALL2 インストレーション・マニュアル

Quick Reference Guide

DBALL2-HYUNDAI9 Remote Start Ready (RSR) Installation

Vehicle Takeover

Press the remote start button on the transmitter to

start the vehicle.*

Press the Unlock button on the factory

or aftermarket remote.*

Enter the vehicle, while making sure the

factory remote is inside with you.

Press the PTS button twice to turn the

ignition ON.

Press the brake pedal, put the car

in gear and drive off.

* Your aftermarket remote may differ from the model shown in the illustrations.

Press

remote start

button*

Press Unlock

button on

either remote*

Enter vehicle

with Smart Key

ENGINE

PUSH

START

STOP

Ready to

drive off

Pit Stop Mode

The Pit Stop Mode feature is practical when you need to stop and run an errand,

but wish to keep the engine running.

Stop the vehicle in a safe parking spot

and put the gear in Park (P).

Press the button to remote start the vehicle.*

It is now safe to leave the engine running and exit the

vehicle with the factory remote in hand.

Note: We recommend that you always lock the doors

of your vehicle when leaving it unattended.

* Your aftermarket remote may differ from the model shown in the illustrations.

Parking Light Error Codes

The parking lights on your vehicle will flash a specific number of times 3 seconds

following an unscheduled shutdown or failure to start. Each flashing pattern is

described below.

Flashes

Diagnostic

Runtime expired.

Over-rev shutdown.

Low/No RPM.

Transmitter shutdown.

Brake shutdown.

Hood shutdown/Remote start safety override switch is ON*.

Remote start safety override switch is ON*.

* If the vehicle hood status is supported through data, it will also report a 7 flash

safety override code.

Stop & put vehicle in Park (P)

Press

remote start

button*

Exit vehicle with

Smart Key