- ページ 6

サンダー Clarke 3110535のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 3110535 13 ページ。 Long bed sander

BEFORE USE

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND COMPRESSED AIR SUPPLY.

1. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done

regardless of whether or not a lubricated air supply is to be used.

2. Connect a suitable hose to the tool as shown using the airline connector

supplied with the tool.

3. If required, connect an in-line mini oiler to the tool.

• A mini oiler helps to prolong the life of the air tool. Remove the oil fill

screw from the side of the mini oiler and fill with air-line oil available

from your CLARKE dealer. Replace the screw before using the tool.

4. If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the inlet strainer or via the hose at

the nearest connection to the air supply.

5. Connect the other end of the hose to the compressor.

6. Turn on the air supply and check for air leaks. Rectify any found before

proceeding. PTFE tape may be useful for sealing threaded connections.

7. Your air tool is now ready for use.

You can fit a whip hose with a quick fit coupling if required (available from your

Clarke dealer.)

• The CAT49 sander requires

70 x 400mm abrasive sheet

Fold the sheet around the

end of the bed and grip it

in position with the spring

clip at each end. Take care

that it is positioned

centrally.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]