- ページ 12

サンダー Clarke 3120193のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 3120193 17 ページ。 Multi-sander kit

GREASING

The right angle drive is fitted with a

grease nipple to provide a facility for

lubrication of the drive gears.

1. After extensive use, apply a shot

of general purpose grease using a

suitable grease gun.

SERVICE AND REPAIR

If the tool runs erratically or becomes

inefficient although the air supply is in

good order, it may be necessary to dismantle the air motor and replace any

worn or damaged parts. Such servicing and repair work should be carried out

by a qualified service technician.

PERFORMANCE

Please note that factors outside the tool may effect its operation and

efficiency such as reduced compressor output, excessive air demand from

the airline, moisture or restrictions in the air-line, or the use of connectors of

improper size or poor condition which will reduce air supply.

**Clarke Air Line Oil (part no. 3050825) is available from your CLARKE dealer.

STORAGE

If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of

Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to

lubricate the internal parts.

When not in use, disconnect from air supply, clean tools and store in the

moulded case provided. When storing, ensure the blanking plug is replaced

on the airline connector once the airline is disconnected.

ACCESSORIES

A wide range of accessories is available including filter/regulators, lubricators,

high-pressure hoses (5 to 50 metres) etc. Contact your CLARKE dealer for

further information or CLARKE International Service Department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]