- ページ 8

サンダー Clarke CAT93のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CAT93 16 ページ。 Hd dual-action sander

ASSEMBLY

INSTALLING THE DISC

1. To assemble the pad to the tool,

turn the locking nut (A) until the

knurled portion contacts the flat

surface on the output spindle (B).

2. Thread the pad into the spindle

by gripping the orbital hub (C)

with one hand and the pad with

the other. Tighten fully.

3. Turn the locking nut (A) until the

spindle (B) turns freely. Do not

operate the tool with the spindle

in the locked mode as performance would be severely affected and a

hazardous situation could result.

FITTING THE SANDING SHEET

1. Peel off the back of the self adhesive sanding sheet and stick it to the

backing pad.

IMPORTANT: Only use abrasive sanding pads designed for use with this type of

150mm dia sanding pad.

CONNECTING THE AIR SUPPLY

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF

COMPRESSORS AND COMPRESSED AIR SUPPLIES.

Note: Ensure the compressor is

turned off.

1. Remove the plastic blanking plug

from the connection port of the

tool.

2. Pour 2-3 drops of CLARKE airline

oil into the air inlet. This should be

done regardless of whether or not

a lubricated air supply is to be

used.

3. Connect a suitable hose to the tool as shown.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]