- ページ 8

サンダー Clarke Contractor CROS2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Contractor CROS2 12 ページ。 Random orbital sander

TROUBLE SHOOTING

Sander Is Overheating

This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed

air or clean with a dry cloth.

Overloading the machine will also cause overheating. Do not use for heavy duty work, and

do not apply excessive pressure.

Excessive Sparking Occurs

This indicates worn brushes. This problem is quickly remedied but you should consult your

CLARKE dealer for parts and advice.

Sander Does Not Operate When Switched ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows

repeatedly, consult your CLARKE dealer.

The Dust Is Not Extracted

Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually caused by

allowing bag to become too full, (remove and empty bag, also clear blockage).

Note :

Ensure sander is switched OFF and isolated from the mains by removing plug from socket.

WARNING!

Make sure that the sander is switched off and disconnected from the mains supply before

starting any cleaning or maintenance procedures.

After use clean out any accumulated dust or chippings etc. Keep the cooling vents

clear. If the sander should become too hot, run it for 2 minutes without load.

Clean the housing with a soft cloth. Any worn or damaged parts should be replaced by

qualified personnel. Keep the handles clean and free from oil and grease. There are no

user serviceable parts inside this sander. Refer to qualified service personnel if internal

maintenance is required.

ACCESSORIES

A wide range of accessories is available from your nearest CLARKE dealer, for further

information, contact your nearest dealer, or telephone CLARKE International Sales

department on 01992 565300