サンダー Clarke Super 7RのPDF 操作と安全性をオンラインで閲覧またはダウンロードできます。Clarke Super 7R 2 ページ。 Dc edger
Clarke Super 7R にも：取扱説明書 (16 ページ), 取扱説明書 (17 ページ), マニュアル (6 ページ)

ページを印刷する

Safety Practices:

Sanding dust is flammable!

Empty and clean dust bag

when not in use.

Always wear safety

goggles, protective

clothing, and a dust mask

while sanding.

Keep the work area well

ventilated.

Sanding/finishing wood

floors can create an

explosive or combustible

environment. Do not

operate this machine

around solvents, thinners,

fuels, floor finishes, or any

other flammable materials.

Keep hands, feet, and

loose clothing away from

all moving parts on the

machine.

Disconnect the power cord

before replacing the pad or

the abrasive.

Never leave the machine

unattended while it is

connected to a power

source.

www.clarkeus.com/rental

Super 7R Edger

Operation and Safety

Application: Sanding wood floors along edges where a drum sander

cannot reach.

Install the Sandpaper Disc

Step

Unplug the machine and turn it upside down.

Using the wrench accessory, remove the screw and

washer from the center of the sanding pad.

Remove the center from a sandpaper disc.

Install the screw and washer in the center of the disc.

Make sure the head of the screw is on the abrasive side

of the disc.

Install the sandpaper disc on the sanding pad.

Tighten the screw until it is secure. Do not over-torque.

Sanding a Wood Floor

Follow the steps in the table below to sand the edges of a wood floor.

Step

Move the machine to the work location and tilt the

machine back so that the sandpaper does not touch the

floor. Make sure the ON/OFF switch is in the OFF position.

Connect the electrical plug to a 3-prong outlet.