- ページ 11

サンダー Clarke Woodworker CBS1-5のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Woodworker CBS1-5 17 ページ。 Belt/disc sander
Clarke Woodworker CBS1-5 にも：取扱説明書 (15 ページ)

ページを印刷する

1. Changing the Sanding Belt

CHANGING THE SANDING BELT

1. Remove the belt table

completely by unscrewing and

removing the table locking lever.

2. Remove the two side cover

securing screws (A), followed by

the upper roller pivot screw (B),

then pull off the side cover.

3. Turn Adjuster (C) anti-clockwise,

sufficiently for the sanding belt to

be slipped off the rollers.

4. Replace the sanding belt ensuring

it is central about the rollers, and

the arrow (D) is pointing down

towards he table.

5. Turn the belt by hand and observe

how it moves on the rollers,

indicated by its position on the

support.

6. This will determine whether or not

it is tracking correctly. If it moves

sideways, turn the adjuster (C), so

that it stabilises over the middle of

the support.

• At this point the belt is tracking

properly. It is tensioned auto-

matically & cannot be adjuste

• Turning the adjuster clockwise will cause the belt to move one

way...turning it anticlockwise and it will have the opposite effect.

CHANGING THE DISC

1. Remove the disc table and lower cover/dust extraction port.

2. Slacken the two screws securing the upper disc cover and slide it back.

3. Using a sharp instrument, tease off a portion of the sanding disc, sufficient

for it to be grasped by hand and peeled off. Remove all residual adhesive

and finally clean the disc with solvent.

4. Peel the backing from the replacement sanding disc and fix to the disc

ensuring it is central. Press it firmly to ensure it is secure.

5. Replace the table and lower disc cover, and adjust gap between table

and disc by positioning and securing the upper disc cover.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]