- ページ 7

水ポンプ Clarke 7150710のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 7150710 13 ページ。 Bore hole pump

The pump is equipped with a thermal-amperometric motor protector. In case

of overload, the motor protector shuts down the pump automatically. When

the motor has cooled the pump starts up again automatically. If the motor

protector steps in, it is absolutely necessary to locate and eliminate the cause

of the malfunction. (refer to troubleshooting on page 8).

NOTE: The water being pumped will be polluted if this pump becomes

damaged and lubricant within the pump escapes.

CARE & MAINTANENCE

WARNING: ELECTRIC SHOCK HAZARD! BEFORE CARRYING OUT ANY

MAINTENANCE OR CLEANING OPERATIONS, DISCONNECT THE PUMP

FROM THE POWER SUPPLY.

This pump does not require any particular maintenance and all repairs must be

carried out by an authorised service centre only.

After removing the pump from the water, drain and rinse with clean water.

To clean the suction filter, use a jet of clean water.

If the pump's turbines need replacement, take the pump to an authorised

service centre.

If the power supply cable is damaged it MUST be replaced by the manufacturer

or an authorised service centre.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]