- ページ 7

水ポンプ Clarke 7238020のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 7238020 17 ページ。 Booster pump
Clarke 7238020 にも：取扱説明書 (17 ページ)

A 1" BSP hose adapter will be required for connection

to the inlet and outlet port. These are available from

your CLARKE dealer.

A foot valve and filter should be fitted to the lower

end of the suction hose as illustrated, so as to help

retain water in the suction system and to prevent the

possibility of large foreign bodies arriving at the

pump/cartridge filter.

A gate valve may be installed in-line on the outlet

side of the pump which can be set as required to

regulate the flow of water. Do not place any such

restriction on the suction side of the pump unless it is

an isolator valve in a gravity fed system.

THE INLET FILTER

An inlet filter is supplied with the

CBT1300SS pump. The filter bowl is

transparent, allowing a visual check

as to the condition of the filter

cartridge. The filter cartridge is a

washable net type with a rated

filtration of 60 microns, suitable for the

efficient removal of suspended

particles such as sand.

The filter is NOT designed to filter mud,

sludge etc and should hang vertically

when installed.

PREPARATION FOR USE

THE PRESSURE VESSEL

This unit operates as a booster pump

by utilising an air chamber with a

pressure regulator switch to provide a

constant pressure at the outlet. The

pump will automatically cut in when

the water pressure reduces to 1.4 Bar

and cut out when the pressure

reaches 3.5 Bar.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]