- ページ 4

水ポンプ Clarke CEB101 7230020のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CEB101 7230020 4 ページ。

ページを印刷する

WIRING CONNECTIONS FOR

CEB101

Make electrical connections inside the

terminal cover in accordance with the

diagram opposite:

WARNING

Do not attempt electrical installation work if you are in any doubt as to

how it should be done properly. Consult a qualified electrician.

WATER CONNECTIONS

IMPORTANT: The pump must not be connected to the power supply until the

hose/pipe installation is completed.

If any part of the system is to be connected to the mains water supply, do ensure

that you comply with your local water authority regulations.

Because of the variety of possible installations, no plumbing accessories are supplied

as standard with your pump. However, accessories designed specifically for this

range of pumps are available from your CLARKE dealer and are listed on page 7.

The pump must always be installed and operated in a horizontal position i.e. with

the outlet port facing vertically upwards. The fixing holes in the base should be

used as necessary to secure the pump firmly in its operating position. Also, ensure

that there is adequate air circulation around the motor.

Avoid situations where there is the risk of

water coming into contact with the outside

of the pump. Neither the motor or the

terminal box are intended to be

waterproof.

These notes are for guidance on how to

achieve a proper working system.

The schematic diagrams illustrate possible

methods of pipework installation. Water

A - Gravity Feed

To Pump

Isolating Valve

intake can be by means of either:- A. Gravity Feed or B. Suction Lift.

Water being taken in by the pump should, whenever possible, be fed by means

of gravity (Method A). However, if this is not possible then water may be drawn

from a lower level by means of suction (Method B).

The suction lift i.e. the vertical

distance between the water level

and the pump should not exceed

distance specified for your pump

(see Specifications on page 7).

When using this method, a foot

valve, must be fitted to the lower

end of the suction hose, (as

illustrated below), so as to help

retain water in the suction system.

The delivery head i.e. the vertical

distance between the pump and

the point of discharge should be

at least 5 feet. If this cannot be

achieved naturally, then it can be

simulated by restricting the outlet

flow from the pump.

The illustration shows a gate valve (V) installed in-

line on the delivery side of the pump which can

be set as required to regulate the flow of water.

Do not place any such restriction on the suction

side of the pump unless it serves only to isolate a

gravity fed water supply.

To prevent unnecessary strain or possible distortion

to the pump, ensure that adequate support is

provided to the hoses and/or pipes. Remember

they will be considerably heavier when filled with

water.

Should sand, chemical or other contaminant come into contact with the pump,

flush through with cold clean water as soon as possible.

Protect the pump and pipework from freezing. The formation of ice may cause

serious damage.

PRIMING

When suction lift is used to draw water into the pump it is essential that all

connections and hoses are completely air tight, otherwise the system will not

work.

Before pumping will start it is necessary to completely fill the suction side with

water. This is known as priming the pump and is carried out as follows :-

B - Suction lift

Outlet Restricter

Valve

Outlet Port

Inlet Port

From Supply

Filter Foot

Valve