- ページ 5

水ポンプ Clarke CEB103のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CEB103 13 ページ。 Water pump

WATER CONNECTIONS

IMPORTANT: The pump must not be connected to the power supply until the

hose/pipe installation is completed.

If any part of the system is to be connected to the mains water supply, ensure

that you comply with your local water authority regulations.

Because of the variety of possible installations, no plumbing accessories are

supplied as standard with your pump. However, accessories designed

specifically for this range of pumps are available from your CLARKE dealer and

are listed on page 7.

The pump must always be installed and operated in a horizontal position i.e.

with the outlet port facing vertically upwards. The fixing holes in the base

should be used as necessary to secure the pump firmly in its operating

position. Also, ensure that there is adequate air circulation around the motor.

Avoid situations where there is the risk of water coming into contact with the

outside of the pump. Neither the motor or the terminal box are intended to be

waterproof.

These notes are for guidance on how to achieve a proper working system.

The schematic diagrams illustrate possible methods of pipework installation.

Water intake can be by means of either:- A. Gravity Feed or B. Suction Lift.

Water being taken in by the pump should,

whenever possible, be fed by means of

gravity (Method A). However, if this is not

possible then water may be drawn from a

lower level by means of suction (Method B).

The suction lift i.e. the vertical distance

between the water level and the pump

should not exceed distance specified for

your pump (see Specifications on page 7).

When using this method, a foot valve, must be fitted to the

lower end of the suction hose, (as illustrated), so as to help

retain water in the suction system.

The delivery head i.e. the vertical distance between the pump

and the point of discharge should be at least 5 feet. If this

cannot be achieved naturally, then it can be simulated by

restricting the outlet flow from the pump.

The illustration shows a Isolating valve installed in-line on the

delivery side of the pump which can be set as required to

regulate the flow of water.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]