- ページ 8

水ポンプ Clarke CGP870のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CGP870 17 ページ。 870w grinder/slurry pump

CONNECTION AND POSITIONING

Remove all packaging and make sure that the unit contains no visible

damage. Dispose of all packaging appropriately.

1. Connect the outlet adaptor to the hose.

• The adaptor fitting allows for connection of 32 mm (1¼"), hoses which

should be secured with a hose clamp.

2. If a long run of discharge hose is being used, any restriction will reduce

capacity and put unnecessary strain on the motor

• Suitable hoses are available from your local CLARKE dealer.

1. It may be safer to raise and lower the pump into deep water using a rope

attached to the lifting handle.

2. Place the pump in a vertical position resting on a firm, flat surface in the

area that you want to drain. If there is sediment in the operating area, the

pump should be placed vertically on house bricks, or similar but ensure

they are not likely to collapse. Never position the pump on sand, silt, mud

or ground which is likely to collapse.

3. Keep the pump clear of sediment by standing it on a platform or brick or

suspending from a rope attached to the handle if the pump is to be used

where there may be silt or mud etc (e.g. garden ponds).

4. Route the hose as straight as possible. Excessive bending of the hose could

obstruct the flow of water, reduce the pumping volume or clog the pump

with mud, thus disabling the pumps function. If the hose is kinked at its base

it will create air pockets in the pump, causing it to operate in a partially dry

state. Take care to straighten any kinks or bends in the hose.

5. DO NOT operate the pump if the water is too shallow. This will be below the

level of the outlet elbow with the impeller fully immersed.

6. Allowance must also be made for the overall width of the pump including

the outlet elbow on one side.

• When the pump is being used in a permanent or semi-permanent

installation, a non-return valve should be fitted in the delivery hose.

Suitable hoses and valves are available from your CLARKE dealer.

• Take all necessary safety precautions as described on pages 4-6.

• The pump inlet must be fully submerged before being switched on.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]