- ページ 3

水ポンプ Clarke CSE400AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CSE400A 7 ページ。 Submersible
Clarke CSE400A にも：取扱説明書 (13 ページ)

ELECTRICAL CONNECTIONS

Their mains lead should be connected to a standard 230Volt (50Hz) electrical supply through

an approved plug or a suitably fused isolator switch. We strongly recommend that these

pumps be fitted with a Residual Current Device (RCD).

NOTE: This is MANDATORY when pump is used for pumping swimming pools and ponds

If the pump is to be connected to an outdoor electrical supply, make sure that both the

plug and the socket are of a BS approved waterproof design.

In the event that the pump is hard wired into the electrical system, it must be carried out in

accordance with IEE regulations.

If used for draining swimming pools or ponds, the pump MUST be fitted with a Residual

Current Device (RCD), with a rated residual operating current of no greater than 30mA.

WARNING: THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in the mains lead are coloured in accordance with the following

code:

As the colours of the flexible cord of this appliance may not correspond with the coloured

markings identifying terminals in your plug proceed as follows:

Connect GREEN & YELLOW cord to plug terminal marked with a letter "E" or

Earth symbol "

Connect BROWN cord to terminal marked with a letter "L" or coloured RED

Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK

The fuse in the plug for this appliance must be rated at 13 amps.

If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-

rewirable) please note:

The plug must be thrown away if it is cut from the electric cable. There is a danger of

electric shock if it is subsequently inserted into a socket outlet.

Never use the plug without the fuse cover fitted.

Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code).

Replacement fuse covers can be obtained from your local dealer or most electrical

outlets

The fuse in the plug must be replaced with one of the same rating (13 amps) and

this replacement must be ASTA approved to BS1362.

If you are in any doubt regarding electrical installation,

Green & Yellow

Blue

Brown

" or coloured GREEN or GREEN & YELLOW.

IMPORTANT:

you should consult a qualified electrician.

Earth

Neutral

Live