- ページ 6
リモートスターター Directed Electronics AS-1775のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics AS-1775 14 ページ。 Smart start 5 button automatic /manual transmission remote starter
Directed Electronics AS-1775 にも： ユーザーマニュアル (13 ページ)
ページを印刷する
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral
position.
2. With the engine already running, apply the parking
brake once and release the brake pedal.
3. Within 20 sec. of engaging the parking brake,
press and hold
transmitter (SmartStart™ uses only
The parking lights will flash 3 times quickly and
remain lit.
4. Remove the key: the engine will keep on running.
5. Exit the vehicle. All doors should be closed, including the hood and trunk.
OPTION 1: No lock
The engine stops.
WARNING: The vehicle is not
armed or locked down.
6. The Parking lights will flash.
Remotestarting
Press the
button for approximately 1 second. The parking lights will turn ON to inform you that
the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving Off
With the vehicle running under remote control, press the
the OEM-style alarm (if installed) and unlock the doors. Enter the vehicle and do the following:
•
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to
the CRANK position while the engine is running. This would cause the starter motor to
re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the "Takeover mode" can be
set for your vehicle.
P.6
,
or
on the
).
NOW THERE ARE THREE POSSIBLE OPTIONS
OPTION 2: Manual shut down
The engine keeps going until you press
either;
•
to lock the doors and shut
down the engine;
•
to unlock the doors and shut
down the engine;
•
to shut down the engine without
affecting the doors.
WARNING: Engine runs until the pre-
programmed run time expires.
during the pre-programmed run time of the engine.
ON
If Ready Mode is enabled by handbrake
2. With the engine already running, apply the parking
brake twice within 10sec.
3. Make sure to release the brake pedal.
The parking lights will flash 3 times quickly and
remain lit.
(default)
button to disarm the Starter Kill and/or
OPTION 3: Automatic shut
down
The engine runs for 8 sec. then
locks the doors before finally
shutting down the engine,
without user interaction.
WARNING: Do not leave your
keys in the vehicle!
User Guide