- ページ 4

水ポンプ Clarke IVP14AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke IVP14A 13 ページ。 Submersible water pump

SAFETY PRECAUTIONS

1. This pump is designed to pump WATER ONLY. Never use for pumping

flammable liquids or chemicals of any kind.

2. NEVER allow the pump to run dry.

3. An approved Residual Current Device (RCD) MUST be used when pumping

from ponds or swimming pools.

4. Your submersible pump may ONLY be used for pumping water from a

swimming pool when there is no person or animal in

the pool.

5. ALWAYS disconnect the pump from the electrical

supply before placing into, or removing from

water, and before any cleaning or

maintenance.

6. When raising or lowering the pump, ALWAYS

use a rope or chain attached to the handle.

NEVER lift or carry the pump by the mains

cable or the float switch cable.

7. DO NOT run the pump with the body

exposed for longer than 10 minutes.

8. DO NOT install the pump on sand, silt, mud etc., or

ground which is likely to shift.

9. If pumping water which is liable to freeze, the pump

MUST be run continuously, otherwise the pump must be removed from the

water and stored in a frost free location.

10. If the pump is to be used where there may be silt or mud (e.g., garden

ponds), ALWAYS keep the pump clear of any sediment by standing it on a

platform or bricks or suspending from a rope or chain attached to the

handle.

11. DO NOT use for permanent installation in pumping clean or pure water,

(particularly drinking water), as there is the remote risk of contamination,

should there be a leak in the seal device.

12. If the mains cable becomes damaged, it MUST be replaced - NOT

repaired. (See Electrical Installation).

13. If used in a confined space - in a shaft or sump etc., ENSURE the float has

sufficient room to operate correctly (see Installation on page 8).

WARNING: FAILURE TO COMPLY WITH THESE SAFETY PRECAUTIONS

COULD BE EXTREMELY HAZARDOUS, NOT ONLY CAUSING A RISK TO

PERSONAL SAFETY BUT ALSO DAMAGE TO THE PUMP, WHICH COULD

INVALIDATE YOUR GUARANTEE.