- ページ 5

リモートスターター Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSIONのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION 16 ページ。 One-way fm automatic/manual transmission remote starter

ページを印刷する

Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter

motor damage that could occur after remote-starting the engine should the user, by force of

habit, turn the ignition key to the CRANK position.

The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm

automatically) or Active Mode (so as to require the user's intervention for arming). By default, your

Remote Car Starter is configured to Passive Mode.

Passive mode:

To arm the Starter Kill, press the

button on the transmitter, OR

In Passive Mode, the Starter Kill will automatically arm 1 minute (by default) or 3

minutes (if configured this way) after the ignition is turned OFF or once the last door is

closed (if the doors are monitored).

The LED on the antenna will flash quickly during the countdown preceding the activation

of the Starter Kill.

Once the activation countdown expires, the LED will send a series of quick double

flashes to indicate that the Starter Kill is now armed.

To disarm the Starter Kill, press the

button on the transmitter.

The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if

configured this way) if no door is left opened (if the doors are monitored) and the ignition

is not turned ON.

Active Mode:

To arm the Starter Kill, press the

button on the transmitter.

The parking lights will flash once.

The LED on the antenna will flash slowly.

If remote door locks are installed, this will also lock the doors and arm the OEM-style

alarm.

To disarm the Starter Kill, press the

button on the transmitter.

The parking lights will flash twice.

The LED on the antenna will remain OFF.

If remote door locks are installed, this will also unlock the doors.

Remote Starting Your Vehicle

Setting Your Vehicle Into Ready Mode

If your vehicle has a manual transmission you must read the following indications. The unit must

first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready

Mode, it cannot remote start the vehicle. Please note that Ready Mode can be enabled by the

remote or the handbrake, depending on the option that was selected by your installer. Therefore,

you must follow the appropriate procedure between the two described below in order to set your

vehicle into Ready Mode.

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.

The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is

pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON

(RUN) position.

To set the system to Ready Mode:

If Ready Mode is enabled by remote

1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the

User guide

If Ready Mode is enabled by handbrake

P.5