- ページ 9

リモートスターター Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTERのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 18 ページ。 Two-way fm led automatic/manual transmission remote starter

ページを印刷する

Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER ユーザーマニュアル

Once the key is in the ON position, press on the brake pedal to put the

transmission in gear. Pressing the brake pedal at this step will cancel the remote

starter takeover.

Drive off.

If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as

that used for Ready Mode (page 7); at the last step, press the

the system and leave the engine running.

NEW FEATURE – Push-To-Start Idle Mode

This feature is a variation of "Idle mode", but made specifically for Push-To-Start vehicles, with

automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the

same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the

engine is running;

Press unlock

Open then close all doors.

You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and

drive off.

Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will shut the engine

down.

Note 2: The engine will continue running until the user re-enters the vehicle or until the expiration

of the run time.

Note 3: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the

vehicle will enter Ready Mode automatically (manual transmissions only).

Caution!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Mode

When the vehicle is in Valet Mode, the remote starter and alarm functionalities are disabled. If the

vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from

being remote-started accidentally.

Any of the following features will put the remote car starter into Valet Mode:

Ignition Valet: This feature allows you to set Valet Mode using the ignition key.

Remote valet: This feature allows you to set Valet Mode using the transmitter.

Using the KEY (Ignition Valet Mode):

Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the

IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.

Turn the ignition OFF.

The LED on the antenna will stay ON indicating that the vehicle has successfully entered

Valet mode.

Using the TRANSMITTER (Remote Valet Mode):

Press and hold the

then beeps once again. Release the buttons.

The

and

The LED on the antenna will stay ON indicating that the vehicle has successfully entered

Valet mode.

User Guide

To put the system into Valet Mode

and

buttons simultaneously until the remote beeps once, pauses,

buttons will flash 3 times.

button to lock the doors, arm

P.9