- ページ 4

バッテリーチャージャー CTEK 1027のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CTEK 1027 8 ページ。 Dc/dc ic recorder

CONNECTINg ThE ChARgER

1. Identify the supply cords and connect the positive power cord to screw terminal marked with IN +

2. Identify the target battery cords and connect the positive power cord to screw terminal marked

with OUT +

3. Connect the negative power cords from supply and target battery to screw terminal marked with

IN - and OUT -.

4. Attach the temperature sensor to the target battery.

Note: Power screws should be fastened with torque 6–8Nm, see picture 2. Exceeding this recom-

mendation may severely damage the charger. Reverse polarity will damage the charger.

Cord should be minimum

6mm² and maximum 1.0m long

Picture 2

BATTERY TYPES AND SETTINgS

D250S is intended for 12V WET, MF, AGM and most GEL lead-acid batteries. Please consult the

battery manufacturer when in doubt.

D250S has a temperature sensor cable. The units will automatically adjust the charging voltage if

the temperature deviates from +25°C. A high temperature lowers the voltage and cold conditions

is handled by higher voltage. The temperature should be measured close to the battery, therefore

attach the sensor to the battery.

Correct torque 6–8Nm

Ring terminals eyelets

should be M8