- ページ 6

フロアマシン Clarke BextSpotのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke BextSpot 16 ページ。 Clarke bextspot 04153a carpet cleaner

ページを印刷する

1. How to Prepare the Machine for Operation

Operating the Machine

Observe the following guidelines, while cleaning:

WARNING: Always use defoamer if foaming

occurs. Foam will suspend large

particles which may damage

vacuum(s), as well as allow liquid

into the vacuum motor(s).

1. Before proceeding, make certain that the nozzle

is functioning properly.

a.To check, hold the hand tool about one foot

above the surface to be cleaned and open the

hand tool valve. A full spray should be

observed form the cleaning nozzle.

b.If the nozzle is not showing a full spray

pattern, adjust nozzle for proper pattern, clean,

or replace nozzle.

2. Normally, chemical is applied on the push stroke

of the hand tool when cleaning. Vacuuming is

done on the pull stroke. For heavily soiled

carpets the hand tool may be used in a scrub-

bing manner, applying chemical in both push and

pull strokes. Always finish up an area with a

vacuum pull stroke.

3. When cleaning, keep the working opening (hand

tool mouth) flat on the surface being cleaned.

Keep the hand tool moving when the valve is

open.

WARNING: Improper discharge of waste may

damage the environment and be

illegal. The United States Environ-

mental Protection Agency has

established certain regulations

regarding discharge of waste

water. Also, city and state regula-

tions regarding the discharge may

be in effect in your area. Under-

stand and follow the regulations in

your area. Be aware of the envi-

ronmental hazards of chemicals

that you dispose.

Page -6-

Shut Down and Daily Maintenance

Shut Down Procedures

For shut down and daily maintenance, follow these

procedures:

1. Turn "OFF" pump and vacuum switch.

2. Unplug power cord from outlet

3. Disconnect hand tool.

4. Open access lid. Pour contents into a five

gallon pail or toilet.

NOTE: We recommend removing as much moisture

from your vacuum hose as is possible. This will

prevent spillage of solution.

5. Unhook the cleaning tool, solution hose, and

vacuum hose.

6. Empty the recovery tank by removing the

access lid from the vacuum tank and pouring the

contents into a five gallon pail or toilet. Dispose

of the waste in a proper manner.

7. Remove any debris or sediment which may have

accumulated inside the recovery tank.

8. Place the access lid back on the recovery tank.

Daily Maintenance Procedures

If properly maintained, this unit will have a long and

trouble-free life. We recommend that you make

these maintenance procedures a part of your daily

work schedule.

CAUTION: Unplug power cord before servic-

ing or making any repairs.

1. Inspect the power cord daily for any sign of

damage. If damaged, replace the cord.

2. Inspect the solution hose daily for any damage.

If the hose shows any signs of damage or

impending rupture, replace the hose.

CAUTION: DO NOT attempt to repair hoses.

Repairing high pressure hoses

may result in severe burns and

serious injury.

3. Inspect the vacuum hose daily for any damage,

breaks, or tears. Repair or replace the hose, if

necessary.

4. Check spray tips daily. Clean spray tips, if

plugged.

5. Monthly or as often as necessary, clean out any

debris which may be in the vacuum tubing and

hose.

Clarke

EXT

POT

Operator's Manual